Cleveland-motion-controls Quantum Tension Controller REV A Manual do Utilizador descarregar pdf (Página 19)

Menu INPUTS

2.3 Diameter Menu

Diameter calibration

With an analog diameter measure, the signal must be calibrated from physical values (upper point

= max diameter, lower point = min diameter).

Valid max diameter: Type in the max diameter value.

Valid min diameter: Type in the min diameter value.

The diameter unit is chosen in the DISPLAY menu.

Procedure: Fill the values and click on memory used, then physically simulate the max diameter

and click on the button "valid max diameter," wait 5 seconds and do the same with min

diameter and the button "valid min diameter."

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 36 37

Sem comentários

Cleveland-motion-controls Quantum Tension Controller REV A Manual do Utilizador Página 19